Pump power loss and heat generation in a pivot bearing-supported Gyro centrifugal pump (C1E3)

Yoshiyuki Takami, Tadashi Nakazawa, Kenzo Makinouchi, Julie Glueck, Yasuhisa Ohara, Robert J. Benkowski, Yukihiko Nosé

研究成果: Article査読

8 被引用数 (Scopus)


Pump power loss is defined as input power that is not used for the output work of the pump. Less pump power loss means a higher pump efficiency. A common opinion is that the pump power loss is closely related to heat generation of the pump, which may affect not only the endurance of pump materials, but also blood damage in a blood pump. In this study, the relationship between pump power loss and heat generation in centrifugal blood pumps was investigated using the pivot-bearing supported Gyro C1E3 pump (C1E3) and Bio-Medicus pump (BP-80) under four different total pressure head/flow conditions. A single special torque measuring driver motor was used for operating both the C1E3 and BP-80 in the four conditions. The pump power loss was calculated from the measured motor torque and hydraulic power. The changes in blood temperature were measured while the pump was operated at room temperature (25°C) to obtain the following findings: First, the C1E3 caused less pump power loss and less temperature increase in blood than the BP-80 in all clinical simulated conditions that were tested; and second, the pump power loss and heat generation had a linear correlation with temperature rise from 22 to 25°C in both the C1E3 and BP-80. During this period, approximately 30% of the pump power loss was transformed to heat, independent of the centrifugal blood pump type, provided that heat conduction through the pump housing and tubing was negligible during this particular period.

ジャーナルArtificial Organs
出版ステータスPublished - 1996

All Science Journal Classification (ASJC) codes

  • バイオエンジニアリング
  • 医学(その他)
  • 生体材料
  • 生体医工学


「Pump power loss and heat generation in a pivot bearing-supported Gyro centrifugal pump (C1E3)」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。